#Mach3 cnc software tutorial driver

It is ONLY for setup and tuning of the motors. Please note that, as the message says before you get to the windows in figure 2, this selection is not for switching the actual displayed coordinates between inches and mm nor is it meant to switch between running part programs written in inches or mm. To do this we go to the Config menu and click Select Native Units and select either inches or mm and click OK. The next thing we need to do is to select the native units of choice. Since we are going to use the computers printer port as the electrical interface between the computer and our machine we make sure that the Normal Printer Port Operation mode is selected and since we don’t want to tell Mach3 this information each time we start the software we put a checkmark in the box next to Don’t mask me this again and then click OK. When the software is started you may be presented with the following dialog but if not don’t worry. Since this tutorial is aimed at getting a milling machine up and running we’ll start the software with the one labelled Mach3Mill. These icons all launches Mach3 but it also loads a different set of screens depending on what kind of machine it is we are running.

After installing the software and rebooting the computer you should have four icons on your desktop.

#Mach3 cnc software tutorial driver

If you don’t do this the software will not work and you will have to manually remove the Mach3 driver from the system. When first installing the software it’s vital to reboot the computer as the installer prompts. The tutorial is based on the Mach3 v2.0 series and is meant to be used as complement to the existing Using Mach 3 Mill manual. We will go thru the steps of setting up the emergency stop, the charge pump circuit the main axis motors, the spindle and coolant as well as the home switches and the software based over-travel limits. The purpose of this tutorial is to help and to guide the user to, step by step, set up and tune the Mach3 CNC controller application for use on a basic 3 axis milling machine.

Mach3 Tutorial Setting up a basic three axis milling machine.